National Instruments AT Instrukcja Użytkownika Pobierz pdf (Strona 159)

Appendix C Uninstalling the Hardware and Software

Figure C-12.

Selecting an Interface to Uninstall

3. ClickontheDelete button.

Note

For shared IRQ AT boards, all ports on the interface are removed.

Uninstall the Software

Before uninstalling the software, remove all serial port information from

the Windows NT Control Panel, as described in the previous section. You

do not need to shut down Windows NT before uninstalling the software.

Complete the following steps to remove the NI-Serial software.

1. Select Start»Settings»Control Panel.

2. Double-click on the Add/Remove Programs icon in the Control Panel

to launch the Add/Remove Programs applet. The Add/Remove

Programs Properties dialog box appears. This dialog box lists the

software available for removal.

3. Select the serial software you want to remove, and click on the

Add/Remove button. The uninstall program runs and removes all

folders, utilities, and registry entries associated with the NI-Serial

software.

4. Shut down Windows NT, power off your computer, and remove your

serial interfaces.

To reinstall the hardware and software, refer to Chapter 5, AT Serial

Hardware Installation, Verification, and Configuration.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 207 208

Brak uwag

National Instruments AT Instrukcja Użytkownika Strona 159